Controller Unit housing the state of art Micro controller card, triac control cards, display cards, and biasing transformer with feedback voltage and current transformers. This unit has all the controls and it is placed in the instrument gallery.
Transformer Unit housing the two step-down transformers and it is placed in the tunnel near to the filaments.
This dual unit design allows user to place the high current drawing transformers in the Transformer (Auxillary) Unit closer to the TiSP feed through hence drastically reducing the voltage drops over long distances compared to conventional single unit Controller when placed in Control/Instrument room/gallery.
Parameters | Value |
Mains Input Supply | 230V AC +/- 10% 50Hz, 1Φ |
Output Power | 150 - 600W+ |
Filament Current | 1 - 60A rms+ |
Filament Voltage | 1 - 9 V AC+ |
Load Filament | ‘U’ hair pin type Filament (85% Ti, 15% Mo) |
Sublimation Pattern | Two pulses each of one minute ‘ON’ separated by an ‘OFF’ period for 1st pump followed by a similar pattern to 2nd pump or Programmable* |
Degassing Pattern | Individual degassing of each filaments (1 – 60A rms each) in continuous mode |
Interval Time | 000:01 - 199:59 HH:MM (Max) + |
Display of Parameters of each PUMP simultaneously on 240 x 60 Graphic Display |
Running Power
Delay Timer Degassing Timer Voltage Current |
Key Board |
START
STOP 5x4 Matrix |
Programmable Parameters of each Pump |
Delay Timer
Degassing Timer Power Over Voltage Over current Pressure Threshold- |
LED Indication |
Pump 1 ON
Pump 2 ON Over Voltage Over Current |
Operation Modes^ |
Manual : by Start – Stop Key
Automatic : by Pressure Threshold (0- 5V) 0V ≡ 1xE-10, 5V ≡ 1xE-4 (Default 1xE-5) Remote : through Ethernet or RS485 |
External Control* | Inhibit , Trigger or Pressure Threshold |
Protection |
Over Voltage+
Over Current+ Thermal (thermostat) |
Communication |
Ethernet
RS485 |
Humidity | 0-80% non-condensing |
Copyright © 2018 Divya Infotech: Complete Control Mumbai, India. All Rights Reserved.
Powered By Lavker Tech